Design Tool: HU & Controls, Tutorial 3 + Exercise Part 3 : Software Support

Design Tool: HU & Controls, Tutorial 3 + Exercise Part 3 Print

Modified on: Wed, 30 Sep, 2020 at 10:54 AM

Applies to FlexLink Design Tool.

Part 3

In this section, we will add Simulations to the previous design that was established in Part 1 and 2.

HU Exercise Part 3

Add Simulation to your layout.

To see if you managed to get it right, check: HU_Exercise_Part3.vcmx where you have the complete layout with added Simulatons.

Now you have finished the HU & Controls training. Well done!

Did you find it helpful? Yes No