Design Tool Basic: Tutorial 3 + Exercise Part 2 : Software Support

Design Tool Basic: Tutorial 3 + Exercise Part 2 Print

Modified on: Wed, 30 Sep, 2020 at 9:17 AM

Applies to FlexLink Design Tool.

In this section, we will continue building the conveyor, that we started in Exercise Alu Part 1, adding an incline conveyor.

First, build the layout according to the pdf drawing: Exercise Alu part 2.pdf

Make sure to save your layout. You will use it in the next exercise.

To see if you managed to get the design right, check: Exercise Alu part 2.vcmx where you have the complete layout.

Did you find it helpful? Yes No